|
Post by swedespeed on Dec 28, 2019 18:16:08 GMT -6
So then I think your bars are 7/8 inch all the way across, right? Pretty sure the 2015/16 bars don't taper up to 1.10" yes as far as I know my stock bars are 7/8" I don't know about tapering or not lol All you have to do is look and see if the bars get thicker where they clamp to the triple tree versus closer to the grips.
|
|
|
Post by 386gsxs750 on Dec 28, 2019 18:41:38 GMT -6
yes as far as I know my stock bars are 7/8" I don't know about tapering or not lol All you have to do is look and see if the bars get thicker where they clamp to the triple tree versus closer to the grips. oh ok...lol no they are the same all the way through
|
|
|
Post by swedespeed on Dec 28, 2019 19:01:50 GMT -6
|
|
|
Post by 386gsxs750 on Dec 28, 2019 19:20:35 GMT -6
|
|
|
Post by 386gsxs750 on Dec 28, 2019 19:21:26 GMT -6
Which that isn't my bike that's just the stock picture they have on their website
|
|
|
Post by swedespeed on Dec 28, 2019 19:24:55 GMT -6
Oh gotcha - I have those too. Didn't realize you already had risers. Anything more than the barbacks and you'd need a longer throttle cable - mine is barely long enough to accommodate these.
|
|
|
Post by 386gsxs750 on Dec 28, 2019 19:33:43 GMT -6
Oh gotcha - I have those too. Didn't realize you already had risers. Anything more than the barbacks and you'd need a longer throttle cable - mine is barely long enough to accommodate these. yeah same as mine they are at their max now. unless there is a way of rerouting the cables to give more slack
|
|
|
Post by swedespeed on Dec 28, 2019 19:37:05 GMT -6
Oh gotcha - I have those too. Didn't realize you already had risers. Anything more than the barbacks and you'd need a longer throttle cable - mine is barely long enough to accommodate these. yeah same as mine they are at their max now. unless there is a way of rerouting the cables to give more slack I tried. There really wasn't a good way to re-route that still looked decent. Motion Pro doesn't make one for our bikes yet either - would be like $200-300 to have one made.
|
|
|
Post by 386gsxs750 on Dec 28, 2019 19:44:48 GMT -6
yeah same as mine they are at their max now. unless there is a way of rerouting the cables to give more slack I tried. There really wasn't a good way to re-route that still looked decent. Motion Pro doesn't make one for our bikes yet either - would be like $200-300 to have one made. oh geez!!!!
|
|