|
Post by custnam on Mar 22, 2018 22:05:28 GMT -6
Hello forum. I have a question about the clutch push rod. I took off the engine sprocket cover to clean it off. I also cleaned the gunk that flung off the chain onto the push rod. But I did not remove the clutch rod itself, just cleaned off the end coming out of the clutch. My question is this. I read on the gsxs manual that the clutch rod should be greased, but it didnt specify where or how much. I think you are only suppose to grease the end that goes into the clutch release lever? But just wanted to make sure. Thanks
|
|
|
Post by mrstamp80 on Mar 23, 2018 5:47:26 GMT -6
Just the end that goes into the linkage. Not a whole lot of grease, just put some on your finger and lightly coat it.
|
|