|
Post by tylerwilliamson on May 25, 2017 20:46:36 GMT -6
The dan moto GP came in today and looked great and came with all the hardware I needed for install. I got the springs on and the can mocked up then I get to the hanger. I cannot for the life of me get this hanger wrapped around the exhaust and bolted to the factory location. It's like the hanger is to short to wrap completely around the can. Anybody else had this problem? Or can give me any advice? I would greatly appreciate it. Cheers.
|
|
|
Post by AshesOfAnother on May 25, 2017 21:37:35 GMT -6
The only danmoto I have is the jisu. I did receive the wrong mid pipe the first time I order it. Check the part numbers with what it should have came with.
|
|
|
Post by siriuslyandrew on May 26, 2017 19:31:22 GMT -6
On my GP Carbon it was a very tight fit. If I remember correctly I couldn't get the strap anywhere near closed when I was installing it, I just got it close enough to get the bolt through then fastened it down. Now that it's been installed for a while, removal and re-install is a breeze.
See if you can get it roughly lined up, just enough to get the bolt through everything, then try and bolt it down.
|
|