|
Post by cobue on May 2, 2018 20:32:33 GMT -6
cobue did your right side chain adjuster end cap keep coming loose, even when you had the correct chain slack set? I found myself having to constantly push the wheel against the adjusters as I was making the adjustment and even then when I applied the final torque to the axle nut, I had to tighten that end cap some so it was not loose. Sorry, i didn't see this. It did go loose at one point but when i tightened back up it was tight again.
|
|
|
Post by Josh on May 4, 2018 14:06:47 GMT -6
"You are adjusting the chain with the bike on a rear stand meaning the rear tire is off the ground?"
Answer: I had the bike on a rear stand the whole time.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 5, 2018 11:20:45 GMT -6
I have my axle on the rotor side of the bike so I can tighten it toward the rotation of tire. So basically I installed the axle on the opposite side of the rim and tighten the axle forward in the same direction that the tire spins. I hope I’m making sense..
|
|