|
|
Post by bubbagsxs750 on Mar 27, 2018 17:03:33 GMT -6
So mine just came in but when I try and connect the midpipe it’s SUPER TIGHT! Wondering what I can do without using an exhaust stretcher. Have some high heat grease. Someone told me use a rubber mallet easily to get it down. Just wondering if there’s any other ideas? Thanks.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 27, 2018 17:14:08 GMT -6
Post some pics of what exactly is the problem.
|
|
|
|
Post by bubbagsxs750 on Mar 27, 2018 17:50:54 GMT -6
It’s saying photos are too big trying from my phone. But it’s bascially where you connect to the slip on to the pipe that has the valve. Then you connect then with the ring.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 27, 2018 20:25:00 GMT -6
you can put a little grease on the outside of the header pipe and a little grease on the inside of your new mid pipe then put a 2x4 piece of wood on the outlet side of your mid pipe a gently tap it with a rubber mallet.
|
|
|
|
Post by AshesOfAnother on Mar 28, 2018 4:39:20 GMT -6
Check for burrs or a raised internal weld that is inhibiting you. I used a carbide bit to "clean" my Noriyoshi before it fit properly.
|
|
|
|
Post by mrstamp80 on Mar 28, 2018 5:48:11 GMT -6
Or take a cresent wrench and and pry the tabs open just slightly.
|
|
